CFD simulation of updrafts initiated by a vertically directed jet fed by the heat of water vapor condensation

This paper presents the results of the development of a mathematical model and numerical simulation of the ascent in the atmosphere of a vertically directed jet fed by the heat of condensation of water vapor on a hygroscopic aerosol introduced into the jet at the start. The possibility of creating artificial convective clouds depending on jet parameters, condensation heat value and vertical profiles of wind speed, air temperature and humidity has been evaluated. Numerical experiments showed that the motion of a high-speed and high-temperature jet in the atmosphere has a complex turbulent nature. As the jet ascends, it expands, losing superheat and velocity. The temperature of the jet decreases faster than the velocity, so the jet rises slightly above the level at which its superheat disappears. The jet's ascent height increases as the humidity of the air and the vertical temperature gradient increase. Wind causes the jet to deform, bend, and decrease the height of ascent. Feed the jet with condensation heat results in a significant increase in jet lift height. This is particularly effective in the case of introducing into the jet two-layer NaCl/TiO₂ nanoaerosol, which is capable of absorbing water vapor in an amount significantly greater than its mass. The simulation results are encouraging in the possibility of creating artificial updrafts that can lead to the formation of convective clouds and precipitation on days with favorable atmospheric conditions, when wind speed in the sub-cloud layer is < 6 m/s, air humidity is > 65%, and the temperature lapse rate is > 7.5 °C/km.