We report on the fabrication of memory devices based on a nanoporous GeSbTe layer electrodeposited inbetween TiN and Ag electrodes. It is shown that devices can operate along two distinct electrical modes consisting of a volatile or a non-volatile resistance switching mode upon appropriate preconditioning procedures. Based on electrical measurements conducted in both switching modes and physical analysis performed on a device after electrical stress, resistance switching is attributed to the formation/dissolution of a conductive filament from the Ag electrode into the GST layer whereas the volatile/non-volatile resistance switching is attributed to the presence of an interface layer between the GST and the Ag top electrode. Due to their simple, low-cost and low-temperature fabrication procedure, these devices could be advantageously exploited in flexible electronic applications or embedded into the back-end of line CMOS technology.