Comparative evaluation of physicochemical and antimicrobial properties of rubber seed oil from different regions of Bangladesh

Heliyon. 2024 Feb 2;10(4):e25544. doi: 10.1016/j.heliyon.2024.e25544. eCollection 2024 Feb 29.

Abstract

In Bangladesh, the annual production of rubber seeds is typically left untapped although the seeds contained a high percentage of oil but underutilized without any value-added utilization. This study aims to evaluate the geographical effect on physicochemical properties, fatty acid composition and the antimicrobial activity of oil extracted from rubber seeds. Seeds were collected from three different regions of Bangladesh and the oil was extracted by the soxhlet method using n-hexane as a solvent. Results demonstrated that the geographical regions have some significant effect on the properties of rubber seed oil (RSO). The physicochemical properties of RSO varied from region to region. For example, the percent of yield, higher heating value, and flash point varied from 50.0 to 50.8 %, 31.8-33.3 kJ/g, and 237-245 °C, respectively. The chemical parameters, such as acid value, iodine value, and hydroxyl value varied from 13.3 to 18.2 mg KOH/g, 132-137 g I2/100g, and 47.7-55.8 mg KOH/g, respectively. Chromatographic analysis showed that RSO mainly contains palmitic, linoleic, linolenic, and stearic acid. Regional variations were also seen in the composition of these fatty acids. Most notably, regardless of the rubber seeds collected from various locations, RSO exhibited inhibitory activity against only gram positive bacteria. The zone of inhibition range for different tested gram positive bacteria was 2.33-11.17 mm irrespective of different RSO samples.

Keywords: Acid value; Antimicrobial activity; Fatty acid composition; Rubber seed oil.