Background: Contaminants and water-soluble salts present in mechanically recycled gypsum from refurbishment and demolition (post-consumer) plasterboard waste limit its use as a secondary raw material in plasterboard manufacturing. This research addresses this limitation, developing a novel acid leaching purification technology combined with an improved mechanical pre-treatment for post-consumer gypsum valorization.
Methods: Laboratory-scale acid leaching purification was performed with a borosilicate beaker, hot plate, and overhead stirrer. Stuccos were produced after calcination of gypsum at 150 °C for 3 hours. Samples were characterized through X-ray fluorescence, X-ray diffraction, thermal gravimetric analysis, scanning electron microscopy and particle size analysis.
Results: Acid leaching at 90 °C for 1 h using a 5 wt% sulfuric acid solution was revealed to be the optimum purification conditions. Stuccos produced from purified gypsum under optimum conditions had similar initial setting times to that of a commercial stucco but with higher water demand, which could be reduced by optimizing the calcination conditions. A magnesium-rich gypsum was precipitated from the wastewater.
Conclusions: Purified post-consumer gypsum with > 96 wt% chemical purity and calcium sulfate dihydrate content was produced. The research recommends acid neutralization prior filtration, use of gypsum particles < 2 mm in size, and stirring speed of 50 rpm to reduce the economic and environmental impacts of the acid leaching purification process at industrial scale. The magnesium-rich gypsum could potentially be marketed as soil fertilizer.
Keywords: Plasterboard waste; acid leaching purification; demolition; post-consumer gypsum recycling; refurbishment.
Plasterboard is a construction material constituted by a gypsum core sandwiched between two paper liners. Plasterboard waste generated in refurbishment and demolition projects, which is known as post-consumer plasterboard waste, contains contaminants such as mortar, plastics, foil and wood, and impurities originating from additives introduced during plasterboard manufacturing and from plasterboard finishings, such as paint and wallpaper. These contaminants and impurities cannot be removed with current mechanical treatments used in plasterboard recycling plants, and post-consumer plasterboard waste is disposed of in landfills. A novel acid leaching purification process was developed here and combined with a modified mechanical treatment that produces high purity recycled gypsum from post-consumer plasterboard waste that fulfils the requirements for plasterboard manufacturing. This new plasterboard recycling technology will prevent plasterboard waste landfilling and increase the recycled content in new plasterboards. As a result, mineral gypsum use in new plasterboards will be reduced, which will lower the environmental impact associated to mineral gypsum extraction and transportation.
Copyright: © 2024 Castro-Diaz M et al.