Bone defects caused by diseases and trauma are considered serious clinical challenges. Autologous and allogeneic transplantations are the most widely used methods to mitigate bone defects. However, transplantation poses risks such as secondary trauma, immune rejection, and disease transmission to patients. Preparing a biologically active bone tissue engineering scaffold as a bone substitute can overcome this problem. In the current study, a PLGA/gelatin (Gel) short fiber-reinforced composite three-dimensional (3D) scaffold was fabricated by electrospinning for bone tissue defect repair. A hybrid scaffold adding inorganic materials hydrotalcite (CaAl-LDH) and osteogenic factors deferoxamine (DFO) based on PLGA and Gel composite filaments was prepared. The structure, swelling, drug release, and compressive resilience performance of the 3D scaffolds in a wet state were characterized and the osteogenic effect of the crosslinked scaffold (C-DLPG) was also investigated. The scaffold has shown the optimum physicochemical attributes which still has 380 kPa stress after a 60% compression cycle and sustainedly released the drug for about twenty days. Moreover, a promisingIn vivoosteogenic performance was noted with better tissue organization. At 8 weeks after implantation, the C-DLPG scaffold could fill the bone defect site, and the new bone area reached 19 mm2. The 3D microfiber scaffold, in this study, is expected to be a promising candidate for the treatment of bone defects in the future.
Keywords: bone regeneration; electrospinning; fiber fragility; osteogenic factor; three-dimensional scaffolds.
© 2024 IOP Publishing Ltd.