Phase-specific damage tolerance was investigated for the AlCoCrFeNi2.1 high entropy alloy with a lamellar microstructure of L12 and B2 phases. A microcantilever bending technique was utilized with notches milled in each of the two phases as well as at the phase boundary. The L12 phase exhibited superior bending strength, strain hardening, and plastic deformation, while the B2 phase showed limited damage tolerance during bending due to micro-crack formation. The dimensionalized stiffness (DS) of the L12 phase cantilevers were relatively constant, indicating strain hardening followed by increase in stiffness at the later stages and, therefore, indicating plastic failure. In contrast, the B2 phase cantilevers showed a continuous drop in stiffness, indicating crack propagation. Distinct differences in micro-scale deformation mechanisms were reflected in post-compression fractography, with L12-phase cantilevers showing typical characteristics of ductile failure, including the activation of multiple slip planes, shear lips at the notch edge, and tearing inside the notch versus quasi-cleavage fracture with cleavage facets and a river pattern on the fracture surface for the B2-phase cantilevers.
Keywords: eutectic system; high entropy alloy; micro-cantilever bending.