Full-contact insoles fabricated from multilayer foams are the standard of care (SoC) for offloading and redistributing high plantar pressures in individuals with diabetes at risk of plantar ulceration and subsequent lower limb amputation. These devices have regional variations in total thickness and layer thickness to create conformity with a patient's foot. Recent work has demonstrated that metamaterials can be tuned to match the mechanical properties of SoC insole foams. However, for devices fabricated using a multilayer lattice structure, having regional variations in total thickness and layer thickness may result in regional differences in mechanical properties that have yet to be investigated. Three lattices, two dual-layer and one uniform-layer lattice structure, designed to model the mechanical properties of SoC insoles, were 3D-printed at three structure/puck thicknesses representing typical regions seen in accommodative insoles. The pucks underwent cyclic compression testing, and the stiffness profiles were assessed. Three pucks at three structure/puck thicknesses fabricated from SoC foams were also tested. Initial evaluations suggested that for the latticed pucks, structure thickness and density inversely impacted puck stiffness. Behaving most like the SoC pucks, a dual-layer lattice that increased in density as structure thickness increased demonstrated consistent stiffness profiles across puck thicknesses. Identifying a lattice with constant mechanical properties at various structure thicknesses may be important to produce a conforming insole that emulates the standard of care from which patient-specific/regional lattice modulations can be made.
Keywords: 3D-printing; Accommodative foot orthosis; Lattice structures; Mechanical properties; Metamaterials.
Copyright © 2023 Elsevier Ltd. All rights reserved.