The damage due to embrittlement of the sintering furnace belt and its replacement after a certain time of use represents a problem for the manufacturers of sintered parts. Finding out the reason for the damage could help to increase the duration of its operation. This research aimed to investigate the causes of embrittlement, considering both the temperatures and atmosphere of the sintering furnace to which the furnace belt is exposed during its operation. The furnace belt was made of AISI 314 stainless steel. Optical microscopy, scanning electron microscopy, combined with energy-dispersive X-ray analysis, X-ray diffraction and the Vickers hardness tests were used to analyze the microstructural, structural, compositional and hardness changes of the belt used for 45 weeks. Cr and Mn carbides, the oxides of Fe, Cr, Mn and Si were found to form at the edge of the furnace belt. The grains grew after 45 weeks of use, approximately 10 times, due to thermal cycles in an endothermic gas atmosphere to which the belt was exposed. Also, the hardness increased from 226 to 338 HV0.05, due to the formation of carbide and oxide-type compounds. All these results represent a starting point in optimizing the lifetime of the sintering furnace belt.
Keywords: Cr depletion; austenitic steel; sintering furnace belt.