Design of the Lanthanum hexaboride based plasma source for the large plasma device at UCLA

Yuchen Qian; Walter Gekelman; Patrick Pribyl; Tom Sketchley; Shreekrishna Tripathi; Zoltan Lucky; Marvin Drandell; Stephen Vincena; Thomas Look; Phil Travis; Troy Carter; Gary Wan; Mattia Cattelan; Graeme Sabiston; Angelica Ottaviano; Richard Wirz

doi:10.1063/5.0152216

Design of the Lanthanum hexaboride based plasma source for the large plasma device at UCLA

Rev Sci Instrum. 2023 Aug 1;94(8):085104. doi: 10.1063/5.0152216.

Authors

Affiliations

¹ Department of Physics and Astronomy, University of California, Los Angeles, Los Angeles, California 90095, USA.
² Department of Mechanical and Aerospace Engineering, University of California, Los Angeles, Los Angeles, California 90095, USA.
³ Department of Chemical Sciences, University of Padova, 1-35131 Padova, Italy.

PMID: 38065131
DOI: 10.1063/5.0152216

Abstract

The Large Plasma Device (LAPD) at UCLA (University of California, Los Angeles) produces an 18 m long, magnetized, quiescent, and uniform plasma at a high repetition rate to enable studies of fundamental plasma physics. Here, we report on a major upgrade to the LAPD plasma source that allows for more robust operation and significant expansion of achievable plasma parameters. The original plasma source made use of a heated barium oxide (BaO) coated nickel sheet as an electron emitter. This source had a number of drawbacks, including a limited range of plasma density (≲4.0 × 1012 cm-3), a limited discharge duration (∼10 ms), and susceptibility to poisoning following oxygen exposure. The new plasma source utilizes a 38 cm diameter lanthanum hexaboride (LaB6) cathode, which has a significantly higher emissivity, allowing for a much larger discharge power density, and is robust to exposure to air. Peak plasma density of up to 3.0 × 1013 cm-33 in helium gas has been achieved. The typical operating pressure is ∼10-5 Torr, while dynamic pressure can be achieved through the gas-puffing technique. Discharges as long as 70 ms have been produced, enabling a variety of long-time-scale studies of processes, such as turbulent particle transport. The new source has been in continuous operation for 14 months, having survived air leaks, power outages that led to rapid temperature changes on the cathode and heater, and planned machine openings. We describe the design, construction, and initial operation of this novel new large-area LaB6 plasma source.