This study aimed to synthesize fluoride-doped bioactive glass (F-BG) based thermo-sensitive injectable hydrogel for endodontic applications. The structural and phase analyses were done with Fourier Transform Infrared spectroscopy and X-ray Diffraction, respectively. The setting time of prepared injectable was investigated at 21°C (in the presence and absence of an ultrasonic scalar) and at 37°C. Flowability was tested according to ISO-6876:2012 specifications, whereas injectability was checked by extrusion method using 21-, 22-, and 23-gauge needles. The in vitro bio-adhesion and push-out bond strength were studied on days 7 and 90 and compared with the commercially available TotalFill®. The ion release profile was analyzed for up to 30 days with Inductively Coupled Plasma Optical Emission Spectroscopy. The fluoride release analysis was conducted periodically for up to 21 days in deionized water and artificial saliva using an ion-selective electrode. The final setting time at 21°C, 21°C+ultrasonic scalar, and 37°C were 38.66±3.21, 29.12±1.23, and 32±3.46 min, respectively. The flowability was 25±3.94 mm, and the injectability coefficient was ≥70.3 for 22, 21, and 57% in a 23-gauge needle. Fluoride release in deionized water was found to be significantly higher than in artificial saliva and increased with time. A significant difference in bond strength was found between days 7 and 90, where the strength was increased, and a new apatite layer was formed on the tooth surface. A rapid release of calcium, phosphate, and silicon ions was seen initially, whereby the continuous release of these ions was observed for up to 30 days. The prepared F-BG injectable hydrogel has shown promising results and has the potential to be used as an endodontic sealer.
Copyright: © 2023 Irshad et al. This is an open access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.