Photocatalytic membranes (PM) have been investigated as an antifouling strategy for membrane separation processes. Coating ceramic membranes with photocatalytic layers can provide a highly active surface capable of degrading foulants and smaller molecules improving the membrane's performance when the surface is irradiated by a suitable light. Nevertheless, the coating process often leads to pore blockage due to the formation or deposition of thick layers of photocatalyst on membrane surfaces, which modifies the original membranes' average pore size and reduces membrane permeability. A facile sol-gel dip coating process was used to produce PM without modifying the original surface morphology of alumina microfiltration membranes. A 3.7-fold increase in permeate volume after 90 minutes of permeation of an acetaminophen solution in continuous filtration mode under UV light (λ = 365 nm LED, 10W) using titania as photocatalyst compared to the bare alumina membrane without irradiation. Furthermore, fouling modeling proved a reduction in the fouling constant, while fouling mechanisms were not modified. Raman analysis showed 100% anatase formed on the membrane surface. Although membranes could remove up to 87% TOC for oily wastewater filtration, antifouling capabilities for this type of effluent were not observed for the photocatalytic membranes mainly due to fouling inside the pores and light attenuation due to the thick fouling layer on the membrane surface.
Keywords: TiO2; acetaminophen; microfiltration; photocatalysis; self-cleaning membrane.