Fixed-bed columns packed with chitosan-magnetite (ChM) hydrogel and chitosan (Ch) hydrogel were used for the removal of arsenate ions from aqueous solutions at a pH of 7.0. The effect of flow rate (13, 20, and 25 mL/h), height of the columns (13 and 33 cm), and initial arsenate concentration (2, 5 and 10 mg/L) on the column's efficiency for the removal of As(V) is reported. The maximum adsorption capacity (qb), obtained before the allowed concentration of contaminant is exceeded, the adsorption capacity (qe) when the column is exhausted, and the mass transfer zone were determined. With this information, the efficiency of the column was calculated, which is given by the HL/HLUB ratio. The higher this ratio, the higher the efficiency of the column. The highest efficiency and the highest uptake capacity value at breakthrough point were obtained when using the lower flow rate, lower initial arsenate concentration, and longer bed length. When 33 cm-high columns were fed with a 10 mg As(V)/L solution at 13 mL/h, the maximum uptake capacity values at exhaustion obtained for Ch and ChM were 1.24 and 3.84 mg/g, respectively. A pH increase of the solution at the column's exit was observed and is attributed to the proton transfer from the aqueous solution to the amino and hydroxyl groups of chitosan. The incorporation of magnetite into Ch hydrogels significantly increases their capacity to remove As(V) due to the formation of complexes between arsenic and the magnetite surface. Experimental data were fitted to the Thomas model, the Yoon-Nelson model and the Bohart-Adams model using non-linear regression analysis.
Keywords: adsorption; arsenate; chitosan; fixed-bed; magnetite.