The aim of this paper is to analyse the mechanical properties of butt joints between S355 steel and 6061-T6 aluminium alloy, as well as their relationship to changes in the structure of the material caused by welding. The effect of the tool offset was analysed in particular. For the analysis, tensile tests were carried out using macro- and mini-specimens taken from S355/AA6061-T6 joints and base materials. In addition, the macro- and microstructure of the joints was determined, the hardness profiles in the joints were analysed, and fractographic analysis of the fractures of the specimens was carried out. Based on the results of the macro- and microstructure examinations, typical friction stir welding (FSW) joint zones were characterised. The microstructure was observed in the interface line of the materials on the root side, the negative effect of which on the quality of the joint was confirmed by digital image correlation (DIC) strain analysis during the monotonic tensile test. The highest average value of su = 141 MPa for the entire joint was obtained for a 0.4 mm tool offset. The highest average value of su = 185 MPa for the selected joint layer was obtained for a 0.3 mm tool offset. Fracturing of the joint in the selected layer for the tool offset values of 0.3 mm and 0.4 mm occurred in the weld nugget zone (WNZ) where the lowest hardness was recorded.
Keywords: dissimilar joints; friction stir welding; mechanical properties; microstructure; welding parameters.