Osteoarthritis knee can be restored by total knee arthroplasty (TKA). Imageless TKA requires several anatomical points to construct a reference coordinate system to measure bone resections and implant placement. Inaccuracies in the definition of the coordinate system lead to malalignment and failure of the implant. While the surgical transepicondylar axis (sTEA) is a reliable anatomical axis to define the lateromedial axis for the femoral coordinate system (FCS), the presence of the collateral ligaments and deterioration of the medial sulcus (MS) make the registration of sTEA a challenging task. In this work, sTEA is assigned using the articular surfaces of the femoral condyles, independent of the lateral epicondyle (LE) and MS. A single 3D arc is marked on each condyle, which is transformed into a 2D arc to get the best-fit curve according to the profile of condyles. The turning point of each best-fit curve, when transformed back to 3D, defines an axis parallel to sTEA. The condyles-based sTEA is measured experimentally on a 3D-printed bone using an Optitrack tracking setup. Using the proposed method, the angle between the aTEA, sTEA, and Whiteside's line was (3.77, 0.55, and 92.72)°, respectively. The proposed method provides the same level of accuracy and improves the anatomical points registration efficiency, as there is no need to register the LE or MS.
Keywords: 3D curve-fitting; Femoral coordinate system; Imageless navigator; Surgical transepicondylar axis; Total knee arthroplasty.
Copyright © 2023 Elsevier Ltd. All rights reserved.