Development of a Portable Low-Cost System for the Metrological Verification of Wheelchair Roller Ergometers

Matteo Lancini; Paolo Spada; Ridi Muhametaj; Rick de Klerk; Lucas H V van der Woude; Riemer J K Vegter

doi:10.1115/1.4062810

Development of a Portable Low-Cost System for the Metrological Verification of Wheelchair Roller Ergometers

J Biomech Eng. 2023 Oct 1;145(10):104501. doi: 10.1115/1.4062810.

Authors

Matteo Lancini¹, Paolo Spada¹, Ridi Muhametaj¹, Rick de Klerk², Lucas H V van der Woude², Riemer J K Vegter²

Affiliations

¹ Medical and Surgical Specialties, Radiological Sciences and Public Health Department, University of Brescia, Via Branze 38, Brescia 25123, Italy.
² Center for Human Movement Sciences, University Medical Center Groningen, University of Groningen, Antonius Deusinglaan 1, Groningen 9713 AV, The Netherlands.

PMID: 37345978
DOI: 10.1115/1.4062810

Abstract

Wheelchair ergometers are widely used in research, clinical practice, and sports environments. The majority of wheelchair ergometers are roller systems that allow for wheelchair propulsion in the personal wheelchair on one or two (instrumented) rollers. Oftentimes these systems are only statically calibrated. However, wheelchair propulsion is dynamic by nature, requiring a dynamic validation process. The aim of the current project was to present a low-cost portable system for the dynamic metrological verification of wheelchair roller ergometers, based on an instrumented reference wheel. The tangential force on the roller is determined, along with its uncertainty, from the reference wheel properties, and compared with the force measured by the ergometer. Uncertainty of this reference wheel system was found to be lower than the one of the ergometer used, indicating that this novel approach can be used for the metrological verification of ergometers.

Publication types

Research Support, Non-U.S. Gov't

MeSH terms

Biomechanical Phenomena
Ergometry*
Wheelchairs*