Objectives: To determine the effect of an extra hydrophobic resin layer (EHL) on the bond strength and durability of three different pH one-step universal adhesives (UAs) utilized in self-etch (SE) mode, and to explore whether UAs can be used as a primer in two-step bonding system.
Methods: Three different pH UAs were utilized: G-Premio Bond (GPB), Scotchbond Universal (SBU), All-Bond Universal (ABU), while the bonding agent of Clearfil SE Bond 2 (SE2) was selected as the EHL. For the EHL groups, EHL was applied after the air blow of each UA and before light curing. The microtensile bond strength (μTBS), fracture modes, interfacial structures and nanoleakage (NL) were evaluated after 24 h water storage and after 15,000 thermal cycling (TC). Elastic modulus (EM) and hardness (H) was tested by a nanoindenter after 24 h.
Results: Significantly higher μTBS was achieved in the GPB+EHL group compared with GPB both at 24 h and after 15,000 TC, while the additional use of EHL did not improve the μTBS of SBU and ABU significantly both at 24 h and after 15,000 TC. GPB+EHL demonstrated lower NL than GPB. The mean EM and H of the adhesive layer in GPB+EHL was significantly decreased compared with GPB.
Conclusions: The results indicated that the bond strength and durability of low pH one-step UA (GPB) were significantly improved by additional application of EHL both at 24 h and after 15,000 TC, while no significant improvement was observed for ultra-mild one-step UAs (SBU and ABU).
Clinical significance: This study indicates that GPB can be used as a primer in a two-step bonding system, while SBU and ABU may not be as effective. These findings may help guide clinicians in selecting the appropriate UAs and bonding techniques for different clinical scenarios.
Keywords: Extra hydrophobic resin layer; Primer; Universal adhesive; pH.
Copyright © 2023 The Author(s). Published by Elsevier Ltd.. All rights reserved.