To solve the problem of insufficient predictability in the classical models for the Ti6242s alloy, a new constitutive model was proposed, based on the partial derivatives from experimental data and the Taylor series. Firstly, hot compression experiments on the Ti6242s alloy at different temperatures and different strain rates were carried out, and the Arrhenius model and Hensel-Spittel model were constructed. Secondly, the partial derivatives of logarithmic stress with respect to temperature and logarithmic strain rate at low, medium and high strain levels were analyzed. Thirdly, two new constitutive models with first- and second-order approximation were proposed to meet the requirements of high precision. In this new model, by analyzing the high-order differential data of experimental data and combining the Taylor series theory, the minimum number of terms that can accurately approximate the experimental rheological data was found, thereby achieving an accurate prediction of flow stress with minimal material parameters. In the new model, by analyzing the high-order differential of the experimental data and combining the theory of the Taylor series, the minimum number of terms that can accurately approximate the experimental rheological data was found, thereby achieving an accurate prediction of flow stress with minimal material parameters. Finally, the prediction accuracies for the classical model and the new model were compared, and the predictabilities for the classical models and the new model were proved by mathematical means. The results show that the prediction accuracies of the Arrhenius model and the Hensel-Spittel model are low in the single-phase region and high in the two-phase region. In addition, second-order approximation is required between the logarithmic stress and logarithmic strain rate, and first-order approximation is required between logarithmic stress and temperature to establish a high-precision model. The order of prediction accuracy of the four models from high to low is the quadratic model, Arrhenius model, linear model and HS model. The prediction accuracy of the quadratic model in all temperatures and strain rates had no significant difference, and was higher than the other models. The quadratic model can greatly improve prediction accuracy without significantly increasing the material parameters.
Keywords: Taylor series; hot compression; partial derivative; prediction accuracy; quadratic model.