This paper presents the results of a study on the development of a Metal active gas (MAG) welding technology for an industrial furnace component made of steel S235JRC+N with respect to the minimizationof welding deformation. A numerical simulation of the welding process was performed in the first phase of the research. The numerical simulation was carried out with the SYSWELD software. For the numerical simulation of the welding process, the FEM method was used. In the simulation, four variants of restraint of the industrial furnace wall panel elements during the execution of the welding process were investigated. They differed in the number of restraints (model 1-4). It was found that the difference between the maximum mean strain in model 1 and the lowest mean strain in model 4 was only 11%. A physical simulation of the welding process was then performed with a restraint variant according to model 1. The displacement results obtained from the physical simulation of the welding process were compared with the displacement results from the numerical simulation. Discrepancies between numerical and physical simulation displacement values were found. The quality of selected welded joints was also evaluated. Visual testing (VT) and measurements of weld geometries were performed for this purpose. Metallographic tests and hardness measurements were performed to determine of influence of the welding process on the microstructure of the welded joint area, especially the heat affected zone (HAZ). The results obtained confirm the correctness of the assumptions made regarding the technology of manufacturing the furnace wall panels.
Keywords: MAG welding method; hardness measurements; metallographic tests; numerical and physical simulation; welding deformation.