Microplastics (MPs) are a widespread environmental threat, especially to aquatic and urban systems. Water quality is vital for biomass production in microalgal-based industries. Here, industrially relevant microalgae Tetraselmis suecica, Scenedesmus armatus, and Nannochloropsis gaditana were exposed to PS- and PE-MPs (polystyrene and polyethylene, respectively - 10-20 μm) contaminated waters (5 and 10 mg/L). Following industrial empirical and ecotoxicological procedures, the production period was established as four days (exponential growth phase). 27-long day experiments were conducted to determine the chronic effects of MPs contamination in microalgal biomass yields. MPs induced different responses in cell density: T. suecica decreased (up to 11 %); S. armatus showed no changes; and N. gaditana increased (up to 6 %). However, all three microalgae exhibited significant decreases in biomass production (up to 24, 48, and 52 %, respectively). S. armatus exposed to PS-MPs and N. gaditana exposed to PE-MPs were the most impacted regarding biomass production. The decrease in biomass yield was due to the reduction in single-cell weight (up to 14, 47, and 43 %), and/or the production of smaller-sized cells (T. suecica). In response to chronic exposure, microalgae showed signs of cell density adaptation. Despite cell density normalizing, biomass production was still reduced compared to biomass production in clean water. Computational modelling highlighted that MPs exposure had a concentration-dependent negative impact on microalgae biomass. The models allow the evaluation of the systematic risks that MPs impose in microalgal-based industries and stimulate actions towards implementing systems to contain/eliminate MPs contamination in the waters used in microalgae production.
Keywords: Biomass; Microalgae; Microplastics; Pollution; Polyethylene; Polystyrene.
Copyright © 2023 The Authors. Published by Elsevier B.V. All rights reserved.