An approach to remove ammonia from mining wastewater is to precipitate ammonia into struvite, and flocculation was proved to enhance settling of struvite flocs. But the current literature fails to consider flocculent properties of struvite flocs, and previous studies focused only on small volumes. This study evaluates the effect of ammonia concentration and height on removal efficiency of struvite flocs in a batch system and compares removal efficiency of struvite flocs between a batch and a pilot-scale continuous settling process to evaluate the potential of using flocculation to recover struvite crystals as a stand-alone method. Removal efficiency of struvite using flocculation is evaluated depending on depth in a batch system for two different ammonia concentrations (45 and 90 ppm) and in a continuous system for different flowrates. It is shown that a higher concentration promotes flocculation and enhances settling velocities of struvite flocs. The difference between the batch and the continuous processes for the same removal efficiency was significantly higher from what has been reported in the literature: in the continuous process, 89% of struvite flocs have been recovered with a surface overflow rate (SOR) of 1.8 m.h-1 , whereas, for the same height, the same efficiency corresponds to SOR = 9 m.h-1 in the batch process. The fragile nature of struvite flocs is potentially responsible for such a difference. PRACTITIONER POINTS: Settling velocities of struvite flocs are highly dependant on concentration and depth. Removal efficiency are considerably higher with a batch settling process for the same surface overflow rate. Flocculation enable 89% of struvite fines to be recovered in a continuous settling process with a SOR of 1.8 m.hs-1 .
Keywords: ammonia; batch versus continuous processes; flocculation; mining wastewater; struvite recovery.
© 2023 The Authors. Water Environment Research published by Wiley Periodicals LLC on behalf of Water Environment Federation.