Continuous-wave (CW) lasing in quasi-two-dimensional (2D) perovskite-based distributed feedback cavities has been achieved at room temperature; however, CW microcavity lasers comprising distributed Bragg reflectors (DBRs) have rarely been prepared using solution-processed quasi-2D perovskite films because the roughness of perovskite films significantly increases intersurface scattering loss in the microcavity. Herein, high-quality spin-coated quasi-2D perovskite gain films were prepared using an antisolvent to reduce roughness. The highly reflective top DBR mirrors were deposited via room-temperature e-beam evaporation to protect the perovskite gain layer. Lasing emission of the prepared quasi-2D perovskite microcavity lasers under CW optical pumping was clearly observed at room temperature, featuring a low threshold of ∼1.4 W cm-2 and beam divergence of ∼3.5°. It was concluded that these lasers originated from weakly coupled excitons. These results elucidate the importance of controlling the roughness of quasi-2D films to achieve CW lasing, thus facilitating the design of electrically pumped perovskite microcavity lasers.