Modern dentistry places great demands on the dental composites used for filling tooth cavities or treating cavitated tooth decay. The aim of the work was to modify the properties of composites by changing the initiators and co-initiators. This was achieved by using initiators based on a quinoxaline skeleton and co-initiators that are derivatives of acetic acid, which is an advantage of these photoinitiating systems due to the elimination of aromatic amines from the photocurable composition. The composites also differed in dental fillers. The effect of the compounds on the exothermicity of the photopolymerization process, the surface morphology of the obtained materials and the maximum compressive strength were determined. The photoinitiating capacity of the two-component systems was tested by the microcalorimetric method using the multifunctional monomer TMPTA, typical for dental filler compositions. The new photoinitiating systems show particularly good efficiency of free radical polymerization initiation, which occurs by the photoinduced intermolecular electron transfer (PET) mechanism. The comparison of the tested systems with camphorquinone, a photoinitiator traditionally used in dentistry, made it possible to observe a decrease in temperature during photopolymerization without a significant decrease in the polymerization rate or increase in photocuring time, as well as a better homogeneity of the surface of the obtained polymeric materials. This indicates that dye-acetic acid derivative systems may be useful in dental applications.
Keywords: dental fillings; dye photoinitiators; photocurable composition; photopolymerization.