In this article, we explored solvents with lower harmfulness than established systems for UV spectrophotometry of lignin. By measuring the absorptivity in DMSO solvent at 280 nm, the purity of the lignin samples was addressed and compared with Klason and acid-soluble lignin. The general trend was an increasing absorptivity with increasing lignin purity; however, considerable scattering was observed around the sample mean. The Hansen solubility parameter (HSP) of four technical lignins was furthermore determined. The model was in line with the UV measurements, as solvents closer in HSP correlated with a higher absorptivity. Ethylene glycol was identified as a good solvent for lignin with low UV-cutoff. In addition, mixtures of propylene carbonate, water, and ethanol showed good suitability and a low cutoff of 215 nm. While DMSO itself was poorly suited for recording alkali spectra, blending DMSO with water showed great potential. Comparing three methods for determining phenolic hydroxyl units by UV spectrophotometry showed some discrepancies between different procedures and solvents. It appeared that the calibrations established with lignin model compounds may not be fully representative of the lignin macromolecule. More importantly, the ionization difference spectra were highly affected by the solvent of choice, even when using what are considered "good" solvents. At last, a statistical comparison was made to identify the most suitable solvent and method, and the solvent systems were critically discussed. We thus conclude that several solvents were identified, which are less harmful than established systems, and that the solubility of lignin in these is a crucial point to address when conducting UV spectrophotometry.
© 2022 The Authors. Published by American Chemical Society.