The paper presents the results of a study on the effectiveness of removing surface defects by brushing. Damage to machine components usually begins on their surface or in the surface layer area. This determines the development of methods, conditions, and process parameters that will positively affect the stereometric and physical properties of the surface layer. Experiments were conducted in which surface defects were generated on a specially designed test stand. By controlling the load and speed of the defect generator it was possible to affect the geometry, depth, and width of the surface defect. A FEM simulation of the brushing treatment was carried out in order to determine the effect of fibers passing through a surface defect in the form of a groove with a small depth and width. It was shown that for certain conditions of brushing treatment, surface defects could be removed effectively. Moreover, the microhardness of the surface layer after the brushing process was analyzed. Changes in microhardness due to brushing reached up to 50 μm for EN AW-2024 aluminum alloy and up to 150 μm for AZ91HP magnesium alloy. The results demonstrated that brushing was an effective method for strengthening the surface layer and that the value of strengthening in the area of defects depended on the effectiveness of their removal.
Keywords: brushing; defects; microhardness; surface roughness.