The aim of the research was to check the possibility of using the non-destructive method of acoustic emission to assess the condition of concrete without dispersed reinforcement and with various additions of curved steel fibres, during three-point bending. An important aspect of the research proposed in the article is the use of a hybrid method of analysis, which involves complementing the results of strength tests, the results of numerical calculations and the results of strain distributions recorded with a digital image correlation system (DIC System, in this research GOM Suite optical system). The operation of the concrete material under load, depending on the amount of fibres added, is reflected in the recorded acoustic emission (AE) signals. The differences concern the number of signals of individual classes and their distribution over time. The differences exist for both low and high load values, which confirms the possibility of using the acoustic emission method to monitor the condition of the material. It was shown that the numerically determined effective stress levels decreased as the proportion of steel fibres in the concrete increased, while the maximum levels of the first principal stresses increased. During the analyses, a preliminary comparison of the deformation results obtained using the finite element method and the DIC System was also carried out.
Keywords: DIC System; acoustic emission method; fibre concrete; numerical analysis; steel fibres.