In industry, forecasting machinery failures could save significant time and money if any maintenance breaks are predictable. The aim of this work was to develop an energy harvesting system which could, in theory, power condition monitoring sensors in heavy machinery. In this study, piezoelectric-cantilever-type energy harvesters were attached to a motor and spun around with different rotational speeds. A mass was placed on the tip of the cantilevers, which were mounted pointing inward toward the center axis of the motor. Pointing a cantilever tip inward and increasing the distance from the center axis of the motor decreased the natural resonance frequency significantly and thus enabled higher harvested energy levels with lower rotational frequencies. Motion of the cantilever was also controlled by altering the movement space of the tip mass. This created another possibility to control the cantilever dynamics and prevent overstressing of the piezoelectric material. Restricting the movement of the tip mass can also be used to harvest energy over a wider frequency range and prevent the harvester from getting trapped into a stagnant position. The highest calculated raw power of 579.2 µW at 7.4 Hz rotational frequency was measured from a cantilever with outer dimensions of 25 mm × 100 mm. Results suggest that an energy harvesting system with multiple cantilevers could be designed to replace batteries in condition sensors monitoring revolving machinery.
Keywords: condition monitoring; energy harvest; piezoelectric; rotational motion; softening effect.