After Le Fort I osteotomy was first performed by von Langernbeck in 1859, there has been many improvements since. Research on and development of Le Fort I osteotomy procedure has shown downward movement of the maxilla to exhibit lowest stability and accuracy. However, maxillary downgraft movement is necessary in orthognathic patients with insufficient vertical length of the maxilla, but fixation of the maxilla after elongation is often very inaccurate. In this study, the authors utilized 3D virtual surgery, CAD/CAM-assisted 3D printing technology to overcome such limitations of maxillary total elongation. In addition, accuracy at 7 different landmarks from superimposition of virtual simulation data and postoperative Cone-beam computed tomography (CBCT) data were measured. Although posterior maxilla exhibited bigger range of errors, an error of <1 mm was measured at all 7 landmarks. Operation time was greatly shortened with cutting guides and customized plates. Although this study is a single-case study, this study shows increased accuracy and efficacy from application of 3D virtual surgery, CAD/CAM, and 3D printing technology.
Copyright © 2022 by Mutaz B. Habal, MD.