The bismuth oxide (Bi2O3) based chloride (Cl-) removal method is one of the chemical precipitation methods possessing good selectivity and high removal efficiency of Cl- ions, but Bi2O3 often appears in the powder form, which is difficult to be recovered for regeneration. In this work, the combination of 3D printing technology and the Bi2O3 method was explored to construct the resin model including the Bi-precursors. In the optimum carbonization process at 400 °C for 30 min, the Bi3+ ions of the Bi-precursor were reduced into the metallic Bi0 nanoparticles, whose surfaces were covered by the thin Bi2O3 layers to form the heterostructured Bi0/Bi2O3 core/shell nanoparticles with an average size of 43 nm. These Bi0/Bi2O3 nanoparticles were tightly adhered to the internal and external surfaces of the hierarchical porous carbon model (Bi-PCM), which greatly facilitated their regeneration and ensured the stable Cl- removal performance. After five cycles of Cl- removal, the chloride removal efficiency over the multiple Bi-PCMs in the dark and pH 1 conditions maintained at about 26%, which then largely increased to 63.6% with UV light irradiation. The light-enhanced mechanism was related to the improved release rate of Bi3+ ions caused by photocorrosion and the Cl• radicals produced from the holes and the •OH and O2•- radicals, which quickly reacted with Bi2O3 to form BiOCl. The construction of Bi-PCMs by using 3D printing technology provides a very promising strategy for the removal of Cl- ions from wastewater.
Keywords: 3D printing; Active free radicals; Bi(0)/Bi(2)O(3) nanoparticles; Chloride removal efficiency; Photocorrosion.
Copyright © 2022 Elsevier Ltd. All rights reserved.