The main aim of the study includes research concerning the strength of samples printed out of 316L steel in the form of laminates and the creation of reflective simulation models with regard to the results obtained during the research. In addition, the tests addressed the effect of the arrangement of the printed layers on the final strength of the object. Static tensile tests allowed the material constants of 316L steel in the form of dimensionally printed laminate to be determined. Tests were conducted on samples with different printed angles. The tests also covered the impact of the printing envelope on samples with the printing angles. Based on the determined material constants, simulation models for calculations using the finite element method were created. Furthermore, the study includes analytical and simulation calculations of plain laminate in order to verify the accuracy of the Composite Layup module in Abaqus CAE software. The study was summarized by compiling and commenting on the results obtained from the conducted research. Tests showed that there is a possibility of simulating the strength of the printouts from 316L steel using the FEM calculations. It was shown that the FEM model results are similar to those obtained in the tests. The calculated errors were from 3.6 to 14.4%. The linear model describes well the first part of the stress-strain curve, but in further research, it is strongly recommended that a proper and checked nonlinear anisotropic one is presented.
Keywords: 3D printing; finite element method; laminate 3D; steel 316L; strength testing.