Dialysis-induced changes in plasma sodium concentration may cause undesirable side effects. To prevent these, the sodium content in dialysis fluid has to be individualized based on the patient's plasma sodium concentration. In this paper, we describe a simple conductivity based method for measuring the plasma sodium concentration. The method is based on performing a bypass during which the residual volume on the dialysate side of the dialyzer at least partially adopts the sodium concentration on the blood side. The conductivity at dialysate outlet of the dialyzer after the end of bypass corresponds to the sodium concentration. We show that already 14 s of bypass are sufficient to subsequently measure a conductivity that correlates with the blood-side sodium concentration. Thus, the short bypass method allows a time saving of 88% compared to the long bypass of 120 s. In vitro experiments with bovine blood show that plasma sodium concentration can be non-invasively and time-efficiently measured during dialysis. Bland Altman analysis reveals a bias of 0.28 mmol/l and limits of agreement of -3.17 and 3.74 mmol/l for the long bypass. For the short bypass, bias is 0.09 mmol/l and limits are -3.90 and 4.08 mmol/l. Since the method presented is based on established conductivity cells, no additional sensors are required, so that the method could be easily implemented in dialysis machines. In future, performing a bypass at the beginning of a treatment may be used to adjust the composition of dialysis fluid individually for each patient.
Keywords: Plasma sodium concentration; bypass method; conductivity; individualized hemodialysis; non-invasive sodium measurement.