Understanding the interface-stabilizing properties of surface-active components is key in designing stable macroscopic multiphase systems, such as emulsions and foams. When poorly soluble materials are used as an interface stabilizer, the insoluble material may sediment and interfere with the analysis of interfacial properties in pendant (or hanging) drop tensiometry. Here, the impact of sedimentation of particles on the interfacial properties determined by pendant drop tensiometry was evaluated using a model system of whey protein isolate and (non surface-active) glass beads (2.2-34.7 μm). Although the glass beads did not adsorb to the air-water interface, a 1% (w/w) glass bead solution appeared to decrease the surface tension by nearly 12 mN/m after 3 h. A similar effect was shown for a mixture of whey proteins and glass beads: the addition of 1% (w/w) of glass beads led to an apparent surface tension decrease of 31 mN/m rather than the 20 mN/m observed for pure whey proteins. These effects are attributed to the sedimentation of particles near the apex of the droplet, leading to droplet shape changes, which are interpreted as a decrease in surface tension using tensiometer software. The droplet density at the apex increases due to sedimentation, and this density increase is not accounted for when fitting the droplet shape with the Young-Laplace equation. The result is the observed apparent decrease in surface tension. In contrast to the significant impact of sedimenting material on the surface tension measurements, the impact on the results of oscillatory deformations was limited. These findings show that the impact of sedimentation should be considered when studying the interface-stabilizing properties of materials with reduced solubility, such as certain plant protein extracts. The presence of such particles should be carefully considered when conducting pendant drop tensiometry.