Water-sensitivity damage is inevitable during hydraulic fracturing for tight reservoir stimulation. A polymer clay stabilizer is the most effective and commonly used agent for reducing this kind of permeability damage. However, due to the small pore throat radii of tight reservoirs, polymers may be captured and detained, resulting in secondary permeability damage caused by polymer plugging. Therefore, it is necessary to clarify the matching relationship between the relative molecular mass of the clay stabilizer and the permeability of tight cores, which has not been reported yet. In response to this problem, the residual resistance factor and the permeability damage rate of PDMDAAC (poly dimethyl diallyl ammonium chloride, a kind of commonly used polymer clay stabilizer) to tight cores from Xinjiang Oilfield were investigated in cores with permeabilities of 0.10 × 10-3 μm2 (0.08-0.17 × 10-3 μm2), 0.05 × 10-3 μm2 (0.035-0.065 × 10-3 μm2), and 0.01 × 10-3 μm2 (0.007-0.020 × 10-3 μm2) through flow experiments. It was found that the relative molecular masses of PDMDAAC, which did not cause obvious core permeability damage, should be less than 10 000, 5000, and 2000, respectively. In addition, the bridging flocculation principle between the hydrodynamics radius of the clay stabilizer and the radius of the tight core pore throat can be used to explain the matching relationship between the relative molecular mass of the polymer clay stabilizer and the permeability of the tight reservoir. This study points out the direction for the optimization of the polymer clay stabilizer used in tight reservoir hydraulic fracturing and provides some references for the construction of hydraulic fracturing fluid systems for the efficient development of unconventional oil and gas resources.
© 2022 The Authors. Published by American Chemical Society.