In this study, water vapor sorption, desorption properties and tensile mechanical properties of four cellulosic fibers, cotton (C), flax (F), viscose (V) and cellulose acetate (CA), were determined. The sorption and desorption isotherms were modeled using the Park model, which allowed an accurate fitting on the whole range of water activity. This model corresponds to a multi-sorption mode dividing in three sorption modes: Langmuir sorption, Henry's law and water clustering. Park's parameters were compared for the sorption and desorption isotherms for each fiber. Regardless of the fiber, differences between sorption and desorption were obtained only for the Henry sorption. The obtained sorption properties were correlated to the accessibility and the amount of sorption sites and also to the crystallinity level of the fibers. It was found that V exhibited the highest water sorption capacity due to a higher hydroxyl groups accessibility and a low amorphous fraction, followed by F, C and CA. Results from tensile tests demonstrated that F and C fibers were more rigid, more resistant and less ductile than CA and V fibers due to a difference of microstructure of the fibers. Finally, the presence of water-sorbed molecules led to a decrease in tensile modulus due to plasticization phenomenon.
Keywords: Park model; cellulosic fiber; tensile properties; water vapor sorption.