Cellulose Nanocrystals' Assembly under Ionic Strength Variation: From High Orientation Ordering to a Random Orientation

Langmuir. 2022 May 24;38(20):6363-6375. doi: 10.1021/acs.langmuir.2c00293. Epub 2022 May 13.

Abstract

We discuss the effect of the ionic strength and effective charge density on the final structural organization of cellulose nanocrystals (CNCs) after drying suspensions with different ionic strengths in terms of quantitative characteristics of the orientation order, rarely considered to date. We observed that increasing the ionic strength in the initial suspension results in continuous shrinking of the helical pitch length that shifts the photonic band gap to a far UV region from the visible range (from 400 to 250 nm) because of the increase in the helical twisting power from 4 to 6 μm-1 and doubling of the twisting angle between neighboring monolayers from 5.5 to 9°. As our estimation of the Coulombic interactions demonstrates, the reduction of the Debye charge screening length below a critical value of 3 nm results in the loss of the long-range helicoidal order and the transition to a disordered morphology with random packing of nanocrystals. Subsequently, very high orientation ordering with the 2D orientation factor, S, within the range 0.8-0.9, close to the theoretical limit of 1, gradually decreased to a very low value of S = 0.1-0.2, a characteristic of random organization at high ionic strength. We suggest that the loss of the chiral ordering is a result of the reduction of repulsive forces, promoting direct physical contact with the reduced contact area during Brownian motion, combined with increased repulsive Coulombic interactions of nanocrystals at nonparallel local packing. Notably, electrolyte addition enhances chiral interactions to the point where the helical twisting power is too large and the resulting nanocrystal bundles can no longer compactly pack without creating unfavorably large free volume. We propose that the Debye charge screening length in suspensions can be used as a universal parameter for CNCs under different conditions and can be used to assess expected ordering characteristics in the solid films.