As an effective alternative for petrochemical-based polymers, bio-based poly (lactic acid) (PLA) foam has been anticipated to alleviate enormous environmental pollution caused by microplastics. However, some difficulties involved in PLA foaming process due to the inherently poor melt strength and crystallization properties. In this context, a small amount of polytetrafluoroethylene (PTFE) was incorporated into PLA matrix to solve the aforementioned issues. Scanning electron microscopy measurement exhibited that PTFE fibrils and their physical networks were formed in molten PLA after blending. Due to these PTFE networks, approximately 2 orders of magnitudes increment in the storage modulus and more than 20% improvement in crystallinity of PLA were obtained. Diverse PLA samples were successfully foamed by a cost-effective, green and supercritical CO2-assisted foaming method. The PLA/PTFE foam with the PTFE content of 5 wt% (PLA/PTFE5) possessed the smallest pore size (9.51 μm) and the highest pore density (2.60 × 108 pores/cm3). In addition, the average specific compressive strength of PLA/PTFE5 foam was enhanced 30% in comparison with that of pure PLA foam. Overall, this study could provide a prospective strategy for developing bioderived and biodegradable polymer foams with controllable pore structures and high compression property.
Keywords: Compression property; Foam; In-situ fibrils; Poly (lactic acid); Polytetrafluoroethylene.
Copyright © 2022 Elsevier B.V. All rights reserved.