Production of high-quality maraging steel is dependent not only on the production technology but also on the alloying design and heat treatment. In this work, cobalt-free, low nickel, molybdenum-containing maraging steel was produced by melting the raw materials in a vacuum induction melting furnace and then refining with a shielding gas electroslag remelting unit. The critical transformation temperatures of the investigated steel samples were determined experimentally by differential scanning calorimetry (DSC) analysis and theoretically aiding Thermo-Calc software. Types and chemical composition plus volume fraction and starting precipitation temperature of suggested constituents calculated with the aid of Thermo-Calc software. The microstructures of forged steel specimens that were heat-treated under several conditions were evaluated by X-ray diffraction (XRD), optical microscopy (OP), scanning electron microscopy (SEM), and electron backscattering (EBSD), in addition to transmission electron microscopy (TEM). The mechanical properties of the investigated steel specimens were evaluated by measuring the tensile strength properties and micro-hardness, furthermore, estimating their fracture surface using scanning electron microscopy at lower magnification. The metallographic results show that the microstructure of steel in aged conditions includes high-alloyed martensite and nickel-rich phase, in addition to the low-alloyed-retained-austenite, intermetallic compounds, and lavas-phase (MoCr). Furthermore, TEM and EBSD studies emphasized that the produced steel has high dislocation density with nano-sized precipitate with an average size of ~19 ± 1 nm. Moreover, the metallographic results show that the mentioned microstructure enhances the tensile properties by precipitation strengthening and the TRIP phenomenon. The tensile strength results show that the n-value of investigated steel passes two stages and is comparable with the n-value of TRIP-steel. Steel characterized by 2100 MPa ultimate tensile strength and uniform elongation of more than 7% can be produced by the investigated production routine and optimum heat treatment conditions.
Keywords: Co-free; Mo-containing; electroslag remelting; maraging steel; mechanical properties.