In the present work, a simplified model of the Fe(111) surface's promoter-oxide system was investigated in order to experimentally verify the previously proposed and known models concerning the structure and chemical composition of the surfaces of iron nanocrystallites in the ammonia-synthesis catalyst. It was shown that efficient oxygen diffusion from metal oxides to the clean Fe(111) iron surface took place even at temperatures lower than 100 °C. The effective wetting of the iron surface by potassium oxide is possible when the surface is covered with oxygen at temperatures above 250 °C. In the TOF-SIMS spectra of the surface of iron wetted with potassium, an emission of secondary FeOK+ ions was observed that implies that potassium atoms are bound to the iron surface atoms through oxygen. As a result of further wetting the iron surface with potassium ions, a heterogeneous surface structure was formed consisting of a thin K2O layer, next to which there was an iron-oxide phase covered with potassium ions. Only a limited increase in calcium concentration was observed on the Fe(111) iron surface upon sample annealing at up to 350 °C. As a result of wetting the iron surface with calcium ions, an oxide solution of CaO-FexOy was formed. In the annealing process of the sample containing alumina, only traces of this promoter diffusing to the iron surface were observed. Alumina formed a solution with a passive layer on the iron surface and under the process conditions (350 °C) it did not wet the pure iron (111) surface. The decrease in Fe+-ion emission from the Fe-Ca and Fe-Al samples at 350 °C implies a reduction in the oxygen concentration on the sample surface at this temperature.
Keywords: TOF-SIMS; diffusion; monocrystalline iron; surface (111); wetting.