Perfume mixtures contain perfume raw materials (PRMs) with varying structures and hydrophobicities, which influence PRM localization within a surfactant-based formulation and thereby affect the phase behavior. In rinse-off products, the addition of water can further affect the phase behavior. In this study, a mixture of 12 PRMs was used as the oil phase in an aqueous system consisting of sodium trideceth-2 sulfate as a primary surfactant, cocamidopropyl betaine as a cosurfactant, and dipropylene glycol as a cosolvent. A series of phase diagrams were constructed with increasing water content, simulating the use conditions for rinse-off products, to determine how the phase boundaries shift with dilution. Using these phase diagrams, the compositions of interest in the micelle without perfume, micelle with perfume, microemulsion, and micelle-microemulsion transition regions were identified at each dilution level. The structural changes were probed through combined small-angle neutron scattering (SANS) and cryo-transmission electron microscopy analyses. The SANS results showed that ellipsoidal micelles were maintained as the perfume content and the dilution level increased. With ≥50 wt % water, increasing the perfume content increased the micelle volume. Interestingly, a higher rate of volume increase was observed at ≥70 wt % water. Notably, the volumes of the micelles with and without perfume increased steadily with dilution, whereas the volumes of the assemblies in the transition region and the microemulsion region increased more rapidly once diluted to 70 and 80 wt % water, respectively.