Fluid catalytic cracking (FCC) unit is one of the means to lighten heavy oil in refineries, and its regenerated flue gas is also the main source of air pollutants from refinery. However, it is not clear about the type and amount of pollutants discharged from FCC units in China. The emissions of regenerated pollutants in the stack flue gases of three typical FCC units in China were investigated in this study, including a partial regeneration unit without a CO boiler (U1), a partial regeneration unit with a CO boiler (U2), and a full regeneration unit (U3). Different monitoring methods were used to analyze the concentration of sulfur dioxide (SO2) and nitrogen oxides (NOx), and the results showed that Fourier transform infrared spectroscopy (FTIR) monitoring results of SO2 and NOx are approximately 10 times and 5 times larger than those of the continuous emission monitoring system (CEMS) data, respectively. Also, the contents of characteristic pollutants such as NH3, C6H6, HCN, C8H8, C2H4, CH4, and CO were also monitored by FTIR, and the emission factors based on coke burn-off rate and throughput were investigated. The pollutants in U1 exhibited relatively higher contents with the NH3, HCN, and C6H6 of 116.99, 71.94, and 56.41 mg/Nm3 in flue gas, respectively. The emission of regenerated pollutants in U2 and U3 are significantly different from U1. Regeneration processes (including coke properties, operating modes, and presence or absence of CO boilers) affected pollutants' emission factors in varying degrees. At last, reasonable emission factors based on the different FCC regeneration processes contribute to the prediction, assessment, and control for the pollutant emission.
Keywords: CO boiler; Emission factor; FCC regeneration pollutants; Full regeneration; Partial regeneration.
© 2021. The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature.