Development of Antifouling Polysulfone Membranes by Synergistic Modification with Two Different Additives in Casting Solution and Coagulation Bath: Synperonic F108 and Polyacrylic Acid

Katsiaryna S Burts; Tatiana V Plisko; Mikael Sjölin; Goncalo Rodrigues; Alexandr V Bildyukevich; Frank Lipnizki; Mathias Ulbricht

doi:10.3390/ma15010359

Development of Antifouling Polysulfone Membranes by Synergistic Modification with Two Different Additives in Casting Solution and Coagulation Bath: Synperonic F108 and Polyacrylic Acid

Materials (Basel). 2022 Jan 4;15(1):359. doi: 10.3390/ma15010359.

Authors

Katsiaryna S Burts¹, Tatiana V Plisko¹, Mikael Sjölin², Goncalo Rodrigues^{2

3}, Alexandr V Bildyukevich¹, Frank Lipnizki², Mathias Ulbricht⁴

Affiliations

¹ Institute of Physical Organic Chemistry, National Academy of Sciences of Belarus, 220072 Minsk, Belarus.
² Department of Chemical Engineering, Lund University, 221 00 Lund, Sweden.
³ Department of Bioengineering, Instituto Superior Técnico, 1049-001 Lisbon, Portugal.
⁴ Lehrstuhl für Technische Chemie II, Universität Duisburg-Essen, 45141 Essen, Germany.

Abstract

This study deals with the development of antifouling ultrafiltration membranes based on polysulfone (PSF) for wastewater treatment and the concentration and purification of hemicellulose and lignin in the pulp and paper industry. The efficient simple and reproducible technique of PSF membrane modification to increase antifouling performance by simultaneous addition of triblock copolymer polyethylene glycol-polypropylene glycol-polyethylene glycol (Synperonic F108, M_n =14 × 10³ g mol^-1) to the casting solution and addition of polyacrylic acid (PAA, M_n = 250 × 10³ g mol^-1) to the coagulation bath is proposed for the first time. The effect of the PAA concentration in the aqueous solution on the PSF/Synperonic F108 membrane structure, surface characteristics, performance, and antifouling stability was investigated. PAA concentrations were varied from 0.35 to 2.0 wt.%. Membrane composition, structure, and topology were investigated by Fourier-transform infrared spectroscopy (FTIR), X-ray photoelectron spectroscopy (XPS), atomic force microscopy (AFM), and scanning electron microscopy (SEM). The addition of PAA into the coagulation bath was revealed to cause the formation of a thicker and denser selective layer with decreasing its pore size and porosity; according to the structural characterization, an interpolymer complex of the two additives was formed on the surface of the PSF membrane. Hydrophilicity of the membrane selective layer surface was shown to increase significantly. The selective layer surface charge was found to become more negative in comparison to the reference membrane. It was shown that PSF/Synperonic F108/PAA membranes are characterized by better antifouling performance in ultrafiltration of humic acid solution and thermomechanical pulp mill (ThMP) process water. Membrane modification with PAA results in higher ThMP process water flux, fouling recovery ratio, and hemicellulose and total lignin rejection compared to the reference PSF/Synperonic F108 membrane. This suggests the possibility of applying the developed membranes for hemicellulose concentration and purification.

Keywords: Synperonic F108; fouling; hemicellulose; membrane modification; polyacrylic acid; polysulfone; ultrafiltration; wastewater treatment.