Experimental data of cathodes manufactured in a convective dryer at the pilot-plant scale, and charge and discharge capacities of half-coin lithium-ion cells

Luis A Román-Ramírez; Geanina Apachitei; Mona Faraji-Niri; Michael Lain; Dhammika Widanage; James Marco

doi:10.1016/j.dib.2021.107720

Experimental data of cathodes manufactured in a convective dryer at the pilot-plant scale, and charge and discharge capacities of half-coin lithium-ion cells

Data Brief. 2021 Dec 16:40:107720. doi: 10.1016/j.dib.2021.107720. eCollection 2022 Feb.

Authors

Luis A Román-Ramírez^{1

2

3}, Geanina Apachitei^{1

3}, Mona Faraji-Niri^{1

3}, Michael Lain^{1

3}, Dhammika Widanage^{1

3}, James Marco^{1

3}

Affiliations

¹ Warwick Manufacturing Group, University of Warwick, Coventry CV4 7AL, UK.
² London South Bank University, 103 Borough Road, London, SE1 0AA, UK.
³ The Faraday Institution, Quad One, Harwell Science and Innovation Campus, Didcot, UK.

Abstract

Megtec Systems pilot-plant scale continuous convective coater. The data was generated as part of an experimental design involving the following coating-drying process variables and ranges: comma bar gap, 80-140 µm; web speed, 0.5-1.5 m/min; coating ratio, 110-150%; drying temperature, 85-110 °C and drying air speed, 5-15 m/s. The manufacturing data include pre-calendered coating thickness, mass loading dry and wet, pre-calendered porosity, spatial autocorrelation and join counting (SAJC) Z-score for carbon and for fluorine, cell thickness, coating weight and porosity of 15 different electrode coatings and 45 half-coin cells. The electrochemical data was obtained at 25 °C in a Maccor 4000 series battery cycler and consists of charge and discharge capacities at C/20, C/5, C/2, 1C, 2C, 5C and 10C C-rates. Discharge gravimetric and volumetric capacities, rate performance (at 5C:0.2C) and first cycle loss data is also reported. Details of the experimental design and a comprehensive analysis of the data can be found in the co-submitted manuscript (Román-Ramírez et al., 2021). Additional collected data not used in Román-Ramírez et al. (2021) is reported in the present manuscript and include visual observations of coating defects, rheological properties of the electrode slurries (solid content, viscosity, coating shear rate and viscosity at coating shear rate), room temperature and room humidity during the coatings and first cycle loss of the coin cells. Raw and analyzed data is made available. The reported data can be used to extend the analysis reported in Román-Ramírez et al. (2021), and for the comparison of relevant data obtained at different manufacturing scales.

Keywords: Capacity; Cathode; Coating; Drying; Electrochemical testing; Experimental data; Lithium-ion battery; Manufacturing.