Experimental Evaluation of Tensile Performance of Aluminate Cement Composite Reinforced with Weft Knitted Fabrics as a Function of Curing Temperature

Bentolhoda Adosi; Seyed Abbas Mirjalili; Mostafa Adresi; Jean-Marc Tulliani; Paola Antonaci

doi:10.3390/polym13244385

Experimental Evaluation of Tensile Performance of Aluminate Cement Composite Reinforced with Weft Knitted Fabrics as a Function of Curing Temperature

Polymers (Basel). 2021 Dec 14;13(24):4385. doi: 10.3390/polym13244385.

Authors

Bentolhoda Adosi¹, Seyed Abbas Mirjalili¹, Mostafa Adresi², Jean-Marc Tulliani³, Paola Antonaci⁴

Affiliations

¹ Department of Textile Engineering, Yazd University, Yazd P.O. Box 8915818411, Iran.
² Department of Civil Engineering, Shahid Rajaee Teacher Training University, Tehran P.O. Box 16785-163, Iran.
³ Department of Applied Science, Politecnico di Torino, P.O. Box 00518460019, 10129 Turin, Italy.
⁴ Department of Structural, Geotechnical and Building Engineering, Politecnico di Torino, P.O. Box 00518460019, 10129 Turin, Italy.

Abstract

Cement composites (CC) are among the composites most widely used in the construction industry, such as a durable waterproof and fire-resistant concrete layer, slope protection, and application in retaining wall structures. The use of 3D fabric embedded in the cement media can improve the mechanical properties of the composites. The use of calcium aluminate cement (CAC) can accelerate the production process of the CC and further contribute to improving the mechanical properties of the cement media. The purpose of this study is to promote the use of these cementitious composites by deepening the knowledge of their tensile properties and investigating the factors that may affect them. Therefore, 270 specimens (three types of stitch structure, two directions of the fabric, three water temperature values, five curing ages, with three repetitions) were made, and the tensile properties, absorbed energy, and the inversion effects were evaluated. The results showed that the curing conditions of the reinforced cementitious composite in water with temperature values of 7, 23, and 50 °C affect the tensile behavior. The tensile strength of the CCs cured in water with a temperature of 23 °C had the highest tensile strength, while 7 and 50 °C produced a lower tensile strength. The inversion effect has been observed in CC at 23 °C between 7 and 28 days, while this effect has not occurred in other curing temperature values. By examining three commercial types of stitches in fabrics and the performance of the reinforced cementitious composites in the warp direction, it was found that the structure of the "Tuck Stitch" has higher tensile strength and absorbed energy compared to "Knit stitch" and "Miss Stitch". The tensile strength and fracture energy of the CC reinforced with "Tuck Stitch" fabric in the warp direction, by curing in 23 °C water for 7 days, were found to be 2.81 MPa and 1.65 × 10³ KJ/m³, respectively. These results may be helpful in selecting the design and curing parameters for the purposes of maximizing the tensile properties of textile CAC composites.

Keywords: calcium aluminate cement; fracture energy; mortar; weft-knitted 3D fabric.