The present paper reports the powder filling of milled electrospun materials in vials, which contained voriconazole and sulfobutylether-β-cyclodextrin. High-speed electrospinning was used for the production of the fibrous sample, which was divided into 6 parts. Each portion was milled using different milling methods and sizes of sieves to investigate whether the milling influences the powder and filling properties. Bulk and tapped density tests, laser diffraction and angle of repose measurements were applied to characterize the milled powders, while a vibratory feeder was used for the feeding experiments. The correlation between the material property descriptors and the feeding responses was investigated by multivariate data analysis. Based on the results, three samples were chosen for the vial filling, which was accomplished with 3400 mg electrospun material containing 200 mg voriconazole, representative of the commercial product. The feed rate was set to fit the 240 g/h production rate of the electrospinning and the relative standard deviation of three repeated vial filling was determined to see the accuracy of the process. This research shows that by applying a suitable milling method it is possible to process electrospun fibers to a powder, which can be filled into vials and used as reconstitution dosage forms.
Keywords: Continuous manufacturing; Electrospinning; Powder feeding; Reconstitution dosage form; Scale-up; Vial filling.
Copyright © 2021 The Authors. Published by Elsevier B.V. All rights reserved.