Objective: The objective of this study was to illustrate the efficacy of a novel imaging analysis technology to capture horizontal and vertical dimensional changes following horizontal alveolar ridge augmentation (HRA).
Methods: Cone-beam computed tomography (CBCT) volumes from 65 HRA sites in 57 patients were available for evaluation, employing a three-dimensional analysis software to overlay preoperative and post-augmentation CBCT volumes. Horizontal and vertical alveolar ridge dimensional (HRD/VRD) changes were recorded considering a panel of patient-, site-, and procedure-related explanatory variables.
Results: VRD changes ranged from -2.9 to 3.0 mm, more than half anterior sites losing alveolar ridge height. Mean HRD increase at the 3- and 5-mm levels apical to the alveolar crest amounted to 2.3±1.6 and 2.4±1.3 mm, respectively, membrane fixation and non-resorbable membrane use associated with significantly greater gains.
Conclusions: To date, studies reporting dimensional changes following HRA predominantly rely on serial in situ orofacial caliper recordings omitting vertical alterations. The protocol employed in this study allows simultaneous HRD and VRD evaluations and assures baseline and post-augmentation recordings are made at the same alveolar ridge position. Compared with in situ recording, CBCT overlay analysis may achieve a more complete characterization of dimensional changes following HRA.
Keywords: allografts; alveolar ridge augmentation; cone-beam computed tomography; dental implants; polytetrafluoroethylene; treatment outcome.