Homogenized or pooled samples of honey bees are already used for monitoring of metal pollution in the environment for a couple of decades. This is the first study that analyzed the elemental composition of individual honey bees. One apiary with 21 hives was used to test in-hive and between-hive differences at the same location. Highest in-hive variability was observed for Al (14.1x), Li (10.3x), V (10.3x), As (8.9x) and Cd (7.9x). For the elements Cu, K, Mg, Na, P, S and Zn the smallest both in-hive (2.3x, 1.8x, 2.0x, 2.2x, 1.9x, 1.7x, 2.4x respectively) as well as between-hive variability (1.5x, 1.4x, 1.4x, 1.6x, 1.4x, 1.4x and 1.5x respectively) was observed. Nonetheless, between-hive variability was statistically significant for all the analyzed elements. We proved that these differences significantly influence comparison of element concentrations in bees from different locations. One hive from Mesić apiary had significantly lower concentrations of Al (hive 18: 18.6 mg kg-1) and U (hive 1: 0.0013 mg kg-1), while at the same time a different hive from the same apiary showed higher concentration of these elements (Al, hive 14: 125 mg kg-1; U, hive 13: 0.012 mg kg-1) compared to another location (thermal power plant, Al: 97 mg kg-1, U: 0.0044 mg kg-1). Therefore, when using honey bees as biomonitors, we recommend a larger number of hives to be sampled at each location to provide an adequate dataset for reliable interpretation of results. Comparing individual bee elemental concentrations, for Na, Mg, P, S, K, Fe, Cu, and Zn negative correlations were found between dry mass of a bee and concentrations of these elements. These negative correlations could be a consequence of higher honey or nectar content in some of the sampled bees. However, this should also be considered when using honey bees as bioindicators.
Keywords: Apis mellifera; Bioindicator; Heavy metals; Hive variability; ICPMS.
Copyright © 2021 The Authors. Published by Elsevier Inc. All rights reserved.