Objectives: This study: 1) aims to measure with high temporal resolution the intrinsic rate of the degree of conversion (DC) of a dental resin-based composite (RBC) photo-cured at two irradiances; 2) aims to determine the transition time at which the DC rate is maximum; 3) used two different irradiances to measure the shift in transition time; 4) aims to compare transition times measured using DC and shrinkage strain.
Methods: Samples (n = 20) 1 mm thick by 10 mm diameter of Filtek One bulk-fill restorative A2 shade (3M Oral Care) were photocured for 20 s with a single emission peak (wavelength centered at 455 nm) light-emitting-diode-based light-curing unit at irradiance levels of 890 mW/cm2 and 209 mW/cm2, and initial sample temperature of T = 23 °C. The DC was measured in real-time using Attenuated Total Reflection (ATR) FTIR spectroscopy with a sampling rate of 13 DC data points per second. The data were analyzed within a phenomenological autocatalytic model. In addition, the axial shrinkage strain was measured using 3 samples of the RBC with the same outer dimensions and under similar experimental conditions using the bonded disk method and an interferometric technique.
Results: For the 890 mW/cm2 and 209 mW/cm2 irradiance levels, the DC with time was found to agree with the model enabling the determination of transition times of 0.66 ± 0.05 s and 2.3 ± 0.2 s, and the DC at these times of 5.5 ± 0.2% and 6.4 ± 0.2%. The maximum linear strain rate at 0.76 ± 0.01 s and 1.98 ± 0.02 s for the 890 mW/cm2 and 209 mW/cm2 irradiance levels, respectively, are within two standard deviations of the corresponding transition times.
Significance: At an irradiance level much greater than 1000 mW/cm2, the photo-polymerization kinetics of a dental RBC may be too fast to be measured accurately using ATR-FTIR spectroscopy. A viable alternative to monitor the kinetics is through the measurements of the axial shrinkage strain employing the bonded disk method and an interferometric technique.
Keywords: Conversion rate; Degree of conversion; FTIR spectroscopy; Interferometry; Irradiance; Photo-polymerization; Polymerization kinetics; Resin composite; Shrinkage strain; Strain rate.
Copyright © 2021 Elsevier Ltd. All rights reserved.