Effect of Nonwoven Carbon Tissue-Reinforced Epoxy Resin Adhesive Layer on the Single Lap Bonding Strength of Aluminum Alloy Joints

Zhifeng Hu; Haijuan Kong; Lei Tao; Mengmeng Qiao; Dongzi Yu; Feiyang Lu; Ahmed Dawelbeit; Muhuo Yu

doi:10.1021/acsomega.1c02635

Effect of Nonwoven Carbon Tissue-Reinforced Epoxy Resin Adhesive Layer on the Single Lap Bonding Strength of Aluminum Alloy Joints

ACS Omega. 2021 Sep 6;6(37):23802-23813. doi: 10.1021/acsomega.1c02635. eCollection 2021 Sep 21.

Authors

Zhifeng Hu^{1

2}, Haijuan Kong³, Lei Tao^{1

2}, Mengmeng Qiao^{1

2}, Dongzi Yu^{1

2}, Feiyang Lu^{1

2}, Ahmed Dawelbeit^{1

2}, Muhuo Yu^{1

2}

Affiliations

¹ State Key Laboratory for Modification of Chemical Fibers and Polymer Materials, Donghua University, Shanghai 201620, China.
² College of Materials Science and Engineering, Donghua University, Shanghai 201620, China.
³ School of Materials Engineer, Shanghai University of Engineer Science, Shanghai 201620, China.

Abstract

The present paper provides a solution to enhance the reliability of bonding. The effect of the nonwoven carbon tissue (NWCT) composite adhesive layer on the bonding strength and reliability of aluminum alloy of single lap joints (SLJ) was investigated by embedding NWCT into the epoxy adhesive layer. The bonding strength, Weibull distribution, metallography of cross section, and fracture surface morphology of NWCT specimens were investigated. The results showed that the average bonding strength and Weibull characteristic strength (WCS) of NWCT-reinforced specimen were 16.78 and 17.17 MPa, which increased by 70.2 and 66.7%, respectively, compared with the neat specimen, and the Weibull modulus increased from 11.46 to 22.83, which indicated that NWCT specimens had higher bonding reliability. The mechanism of microcrack formation was obtained by analyzing the cross section of specimen loaded 95% WCS without macroscopic damage. The metallographic section showed that the microcrack of the neat specimen originated from the adhesive-aluminum interface, while the microcracks of the NWCT specimen originated from the interface between short carbon fibers (SCF) and adhesive. Typical failure modes were gained from visual observation and SEM. The failure mode of the neat specimen included more Al-adhesive interface failure, while the NWCT specimen included more internal failure of adhesive-SCFs with the fracture, pullout, peeling, and slippage of SCFs improving the toughness and bonding strength of the adhesive layer. The bridging effect of SCFs in the adhesive layer reinforced by NWCT can even the load and release the stress to improve the bonding reliability.