Co-Spray Drying of Paracetamol and Propyphenazone with Polymeric Binders for Enabling Compaction and Stability Improvement in a Combination Tablet

Ioannis Partheniadis; Ioannis Nikolakakis; Constantinos K Zacharis; Kyriakos Kachrimanis; Nizar Al-Zoubi

doi:10.3390/pharmaceutics13081259

Co-Spray Drying of Paracetamol and Propyphenazone with Polymeric Binders for Enabling Compaction and Stability Improvement in a Combination Tablet

Pharmaceutics. 2021 Aug 14;13(8):1259. doi: 10.3390/pharmaceutics13081259.

Authors

Ioannis Partheniadis¹, Ioannis Nikolakakis¹, Constantinos K Zacharis², Kyriakos Kachrimanis¹, Nizar Al-Zoubi³

Affiliations

¹ Laboratory of Pharmaceutical Technology, Department of Pharmaceutical Technology, School of Pharmacy, Faculty of Health Sciences, Aristotle University of Thessaloniki, 54124 Thessaloniki, Greece.
² Laboratory of Pharmaceutical Analysis, Department of Pharmaceutical Technology, School of Pharmacy, Faculty of Health Sciences, Aristotle University of Thessaloniki, 54124 Thessaloniki, Greece.
³ Department of Pharmaceutics and Pharmaceutical Technology, Faculty of Pharmaceutical Sciences, The Hashemite University, 13133 Zarqa, Jordan.

Abstract

Paracetamol (PCT) and propyphenazone (PRP) are analgesic drugs that are often combined in a single dosage form for enhanced pharmacological action. In this work, PCT and PRP were co-spray dried separately with hydroxypropyl methylcellulose (HPMC) and hydroxypropyl cellulose (HPC) using drug suspensions in polymer solutions as feed liquids. It was thought that because of polymer adherence to the surface of drug particles, the risk of PCT-PRP contact and interaction could be reduced. Such interaction may be caused by localized temperature gradients due to frictional forces during tableting, or during storage under harsh conditions. A worst-case scenario would be eutectic formation due to variations in powder mixture homogeneity since eutectic and therapeutic mass PCT/PRP ratios are close (65:35 and 60:40, respectively) and eutectic temperature is low (~56 °C). Uniform particle size, round shape, compaction improvement and faster release of the analgesics were important additional benefits of co-spray drying. Experimental design was first applied for each drug to optimize the polymer concentration on the yield of spray drying and melting point separation (Δmp) of heated binary mixtures of co-spray dried PCT/neat PRP, and vice versa, with the two drugs always included at their therapeutic 60:40 ratio. Optimal combinations with largest Δmp and production yield were: co-spray dried PCT (15% HPC) with neat PRP and co-spray dried PRP (10% HPMC) with neat PCT. Compression studies of these combinations showed tableting improvement due to the polymers, as reflected in greater work of compaction and solid fraction, greater fracture toughness and tablet strength, easier tablet detachment from the punch surface and ejectability. Faster release of both drugs was obtained from the tablet of co-spray dried PCT (15% HPC) with neat PRP. A one-month stability test (75% RH/40 °C) showed moisture-induced alteration tablet strength.

Keywords: combination therapy; compressibility; diametrical loading; experimental design; spray drying; thermal analysis.