Orodispersible films (ODFs) address the needs of pediatric and geriatric patients and people with swallowing difficulties due to fast disintegration in the mouth. Typically, they are obtained using the solvent casting method, but other techniques such as 3D printing and electrospinning have already been investigated. The decision on the manufacturing method is of crucial importance because it affects film properties. This study aimed to compare electrospun ODFs containing aripiprazole and polyvinyl alcohol with films prepared using casting and 3D printing methods. Characterization of films included DSC and XRD analysis, microscopic analysis, the assessment of mechanical parameters, disintegration, and dissolution tests. Simplified stability studies were performed after one month of storage. All prepared films met acceptance criteria for mechanical properties. Electrospun ODFs disintegrated in 1.0 s, which was much less than in the case of other films. Stability studies have shown the sensitivity of electrospun films to the storage condition resulting in partial recrystallization of ARP. These changes negatively affected the dissolution rate, but mechanical properties and disintegration time remained at a desirable level. The results demonstrated that electrospun fibers are promising solutions that can be used in the future for the treatment of patients with swallowing problems.
Keywords: 3D printing; aripiprazole; electrospinning; orodispersible films; solvent casting.