Herein, we report a novel renewable pH-responsive starch-based flocculant (CIAT-ST) via etherifying 2-chloro-4,6-isopropylamino-[1,3,5]-triazine (CIAT) onto the starch backbones for decontamination and reuse of highly saline effluents. The obtained CIAT-ST shows a unique pH-sensibility and reversibility in response to a subtle pH change due to a pH-controllable surface charge density of polymer chains. The level of residual CIAT-ST in the solution can be facilely monitored by using UV-vis detection. The dye flocculation performance of CIAT-ST was evaluated by using a batch experiment. The results exhibited that the dye removal was highly dependent on the solution pH (optimal pH was 2), the flocculation equilibrium can be achieved within 5 min, and the maximum flocculation capacity of CIAT-ST for K-2BP and KN-B5 were calculated to be 2452.6 ± 23.9 and 792.7 ± 14.1 mg/g, respectively. The multiple flocculation mechanisms, including charge neutralization, bridging and charge patching, may participate in the flocculation process. Adjustment in pH-mediated hydrophilicity-hydrophobicity switch of flocculant facilitates readily recovery and then sequentially reused three times while retaining satisfying flocculation efficiency. A significant contribution was also confirmed that the highly saline effluents after flocculation and sedimentation were reused in three successive dyeing processes without sacrificing fabric quality (ΔE* < 1) due to relatively low polymer residuals, and the efficiency of salt reuse for consecutive regeneration processes could be achieved above 85%. The present work could provide alternative thoughts for the reutilization of spent flocculant and clarified saline wastewater, which is also an efficient and sustainable strategy for textile wastewater management.
Keywords: Flocculant sequential regeneration; Resource recovery; Saline wastewater reuse; Starch-based flocculant; pH-responsive.
Copyright © 2021 Elsevier Inc. All rights reserved.